Series 2000 Magnehelic® Differential Pressure Gages

Series 2000 Magnehelic® Differential Pressure Gages

Series 2000 Magnehelic® Differential Pressure Gages

Service
  • Air and non-combustible, compatible gases(natural gas option available).
  • Note: May be used with hydrogen. Order a Buna-diaphragm. Pressures must be less than 35 psi
Product Enquiry

Applicable standards

Type Magnehelic & Digital Gauges
Model Name 2000
Wetted Materials Consult factory.
Housing Die-cast aluminum case and bezel, with acrylic cover, Exterior finish is coated gray to withstand 168-hour salt spray corrosion test.
Accuracy ±2% (-HA model ±1) of FS (±3% (-HA ±1.5%) on -0, -100PA, -125PA, -10MM and ±4% (-HA ±2%) on -00, -60PA, -6MM ranges), through out range at 70°F (21.1°C).
Pressure Limits -20 in Hg. to 15 psig.† (-0.677 bar to 1.034 bar)| MP option: 35 psig (2.41 bar) | HP option : 80 psig (5.52 bar)
Enclosure Rating Ip 67
Over Pressure The relief plug opens at approximately 25 psig (1.72 bar), standard gages only. See Overpressure Protection note on Catalog page
Temperature Limits 20 to 140°F (-6.67 to 60°C) | -20°F (-28°C) with low temperature option
Size 4″ (101.6 mm) diameter dial face.
Mounting Orientation The diaphragm in vertical position. Consult factory for other position orientations
Process Connections 1/8″ female NPT duplicate high and low-pressure taps – one pair side and one pair back.
Weight 1 lb 2 oz (510 g) | MP & HP 2 lb 2 oz (963 g).
Standard Accessories Two 1/8″ NPT plugs for duplicate pressure taps, two 1/8″ pipe thread to rubber tubing adapters, and three flush mounting adapters with screws. (Mounting and snap ring retainer substituted for three adapters in MP & HP gage accessories.)